Fun Food Catering © All rights reserved. Privacy Policy | Terms of Use
Home Page. Services. Infomation. Contact Us. Fun Food Catering Home Page. Services. Infomation. Contact Us.

CHAMPAGNE FOUNTAIN HIRE

PUNCH FOUNTAIN  HIRE


To make the fountain flow continuously

The fountain must have a minimum of 4 litres

of liquid in the bowl for the pump to operate.

DO NOT RUN THE MACHINE WITHOUT LIQUID

IN THE BOWL OR IMMERSE THE BASE IN WATER


ASSEMBLE OF THE FOUNTAIN


1/ Put the silver plate over the threaded part of the shorter plastic plastic pole and screw the longer plastic pole on to the shorter plastic pole, securing the silver plate in between the two poles.

2/ Place the bowl with the larger hole over the thread plastic pole in the center of the fountain. Screw the assembled poles with the plate, on to the thread pole in the center of the fountain.

3/ place the statue over the top of the plastic pole assembly.

Complete the fountain by using either or both the challis cup and the bowl (with small hole).

Place the chosen cup / bowl on the top of the statue, Insert the stainless steel screw with washer through the centre hole(s) of the cup /bowl and hand tighten.

4/Before using the fountain, check that it is level by sing a spirit level at 90 degrees positioning.


MAKING THE FOUNTAIN FLOW


If the Fountain is going to be used with a punch recipe, ensure that the punch is ‘bit’ free by straining the mix through a sieve.

Pour the champagne or the punch in to the large lower bowl. Turn the switch to on.

If the beverage does not circulate within a minute, turn the fountain off for 10 seconds and repeat this  procedure until the beverage flows. Should this procedure fail, pour beverage in to the top reservoir, with the fountain running, until the pump is activated.

If the flow of the beverage is to fast or too slow - Adjust the flow with a screwdriver through the ½ inch hole located in the upper part of the motor cover (frosted perspex cover).


CLEANING THE FOUNTAIN


Dismantle the top assembly and wash separately. Empty remaining beverage and fill bowl with warm soapy water. Switch the machine on and let the liquid circulate for 10 minutes. Switch off and empty bowl. Repeat process with clean warm water. DO NOT USE SCOURING PADS OR ANT TYPE OF ABRASIVE.


Power requirements; 235 volts, 0.7amps, 92 watts.

Size: 50cm diameter x 80cm high

Wedding Champagne Fountain

Punch Fountain Hire

Ascot, Bracknell, Central London  Maidenhead, Reading, Slough, Staines, West London, Windsor.

Berks, Berkshire, Bucks, Buckinghamshire, Middlesex, Oxfordshire, Surrey, UK.